Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 586)

530 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
25
CFM Commands
Command Usage
This command can be used to clear AIS defect entries if a MEP does not exit the AIS state when all
errors are resolved.
Example
This example clears AIS defect entries on port 1.
Console#clear ethernet cfm ais mpid 1 md voip ma rd
Console(config)#
show ethernet cfm configuration
This command displays CFM configuration settings, including global settings, SNMP traps, and
interface settings.
Syntax
show ethernet cfm configuration {global | traps | interface [interface] | delay-measure group
[group-index] | loss-measure single-ended group [group-index]}
global – Displays global settings including CFM global status, cross-check start delay, and
link trace parameters.
traps – Displays the status of all continuity check and cross-check traps.
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
group-index – Index for a group of delay-measure or loss-measure messages attributes.
(Range: 1-200)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the global settings for CFM.
Console#show ethernet cfm configuration global
CFM Global Status : Enabled
Crosscheck Start Delay : 10 seconds
Linktrace Cache Status : Enabled
Linktrace Cache Hold Time : 100 minutes
Linktrace Cache Size : 100 entries
Console#
This example shows the configuration status for continuity check and cross-check traps.
Console#show ethernet cfm configuration traps
CC MEP Up Trap : Disabled
CC MEP Down Trap : Disabled