Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 64)

8 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
1
System Defaults
Ethernet Ring
Protection
Switching
ERPS can be used to increase the availability and robustness of Ethernet rings, such as those used
in Metropolitan Area Networks (MAN). ERPS provides Layer 2 loop avoidance and fast
reconvergence in Layer 2 ring topologies, supporting up to 255 nodes in the ring structure. It can
also function with IEEE 802.1ag to support link monitoring when non-participating devices exist
within the Ethernet ring.
IP Routing The switch provides Layer 3 IP routing. To maintain a high rate of throughput, the switch forwards
all traffic passing within the same segment, and routes only traffic that passes between different
subnetworks. The wire-speed routing provided by this switch lets you easily link network segments
or VLANs together without having to deal with the bottlenecks or configuration hassles normally
associated with conventional routers.
Static Routing – Traffic is automatically routed between any IP interfaces configured on the switch.
Routing to statically configured hosts or subnet addresses is provided based on next-hop entries
specified in the static routing table.
System Defaults
The switch’s system defaults are provided in the configuration file “Factory_Default_Config.cfg.” To
reset the switch defaults, this file should be set as the startup configuration file.
The following table lists some of the basic system defaults.
TABLE 2 System Defaults
Function Parameter Default
Console Port Connection Baud Rate 9600 bps
Data bits 8
Stop bits 1
Parity none
Local Console Timeout 0 (disabled)
Authentication and
Security Measures Privileged Exec Level Username “admin”
Password “admin”
Normal Exec Level Username “guest”
Password “guest”
Enable Privileged Exec from Normal
Exec Level Password “super”
RADIUS Authentication Disabled
TACACS+ Authentication Disabled
802.1X Port Authentication Disabled
MAC Authentication Disabled
HTTPS Enabled
SSH Disabled
Port Security Disabled
IP Filtering Disabled
DHCP Snooping Disabled