Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 613)

Brocade 6910 Ethernet Access Switch Configuration Guide 557
53-1002651-02
25
CFM Commands
ethernet cfm delay-measure group
This command sets attributes for periodically transmitted delay-measure messages, including
transmission cycle, duration, interval, and timeout. Use the no form to delete an attribute group.
Syntax
ethernet cfm delay-measure group group-index [cycle cycle] [duration duration]
[interval interval] [size packet-size] [timeout timeout]
no ethernet cfm delay-measure group group-index
group-index – Attribute group index. (Range: 1-200)
cycle – The periodic cycle at which delay-measure messages are transmitted.
(Range: 1-24 hours)
duration – The duration of each transmission. (Range: 1-60 minutes)
interval – The interval between each transmission. (Range: 1-5 minutes)
packet-size – The size of the delay-measure message. (Range: 64-1518 bytes)
timeout - The timeout to wait for a response. (Range: 1-5 seconds)
Default Setting
Cycle: 4 hours
Duration: 10 minutes
Interval: 1 minute
Packet Size: 64 bytes
Timeout: 1 second
Command Mode
Global Configuration
Command Usage
• The attributes of an existing group cannot be modified. First delete the group, and then use
this command to specify the required changes.
• If a group is bound to any MEP, that group cannot be deleted.
• When a MEP is deleted, the group binding is also removed.
• The "timeout" parameter only applies to two-way delay-measure messages.
• The "interval" parameter must be less than or equal to the "duration" parameter.
Example
This example sets the attributes for periodic delay-measure message transmission.
Console(config)#ethernet cfm delay-measure group 1 cycle 24 duration 60 interval 5
size 128 timeout 2
Console(config)#