Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 287)

Brocade 6910 Ethernet Access Switch Configuration Guide 231
53-1002651-02
10
ARP Inspection
show ip arp inspection interface
This command shows the trust status and ARP Inspection rate limit for ports.
Syntax
show ip arp inspection interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show ip arp inspection interface ethernet 1/1
Port Number Trust Status Limit Rate (pps)
------------- -------------------- ------------------------------
Eth 1/1 Trusted 150
Console#
show ip arp inspection log
This command shows information about entries stored in the log, including the associated VLAN,
port, and address components.
Command Mode
Privileged Exec
Example
Console#show ip arp inspection log
Total log entries number is 1
Num VLAN Port Src IP Address Dst IP Address Src MAC Address Dst MAC Address
--- ---- ---- -------------- -------------- --------------- --------------
1 1 11 192.168.2.2 192.168.2.1 00-04-E2-A0-E2-7C FF-FF-FF-FF-FF-FF
Console#
show ip arp inspection statistics
This command shows statistics about the number of ARP packets processed, or dropped for
various reasons.
Command Mode
Privileged Exec
Example
Console#show ip arp inspection statistics
ARP packets received before rate limit : 150
ARP packets dropped due to rate limt : 5