Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 939)

Brocade 6910 Ethernet Access Switch Configuration Guide 883
53-1002651-02
42
Access Control Lists
Setting A Time Range
Use the Security > ACL (Configure Time Range) page to sets a time range during which ACL
functions are applied.
CLI References
• “Time Range” on page 101
Command Usage
If both an absolute rule and one or more periodic rules are configured for the same time range (i.e.,
named entry), that entry will only take effect if the current time is within the absolute time range
and one of the periodic time ranges.
Parameters
These parameters are displayed:
Add
• Time-Range Name – Name of a time range. (Range: 1-16 characters)
Add Rule
• Time-Range – Name of a time range.
• Mode
• Absolute – Specifies a specific time or time range.
• Start/End – Specifies the hours, minutes, month, day, and year at which to start or
end.
• Periodic – Specifies a periodic interval.
• Start/To – Specifies the days of the week, hours, and minutes at which to start or end.
Interface
To configure a time range:
1. Click Security, ACL.
2. Select Configure Time Range from the Step list.
3. Select Add from the Action list.
4. Enter the name of a time range.
5. Click Apply.
FIGURE 201 Setting the Name of a Time Range