Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 524)

468 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
23
IGMP Filtering and Throttling
deny - The new multicast group join report is dropped.
replace - The new multicast group replaces an existing group.
Default Setting
Deny
Command Mode
Interface Configuration (Ethernet)
Command Usage
When the maximum number of groups is reached on a port, the switch can take one of two actions;
either “deny” or “replace.” If the action is set to deny, any new IGMP join reports will be dropped. If
the action is set to replace, the switch randomly removes an existing group and replaces it with the
new multicast group.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp max-groups action replace
Console(config-if)#
show ip igmp filter
This command displays the global and interface settings for IGMP filtering.
Syntax
show ip igmp filter [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show ip igmp filter
IGMP filter enabled
Console#show ip igmp filter interface ethernet 1/1
Ethernet 1/1 information
---------------------------------
IGMP Profile 19
Deny
Range 239.1.1.1 239.1.1.1
Range 239.2.3.1 239.2.3.100
Console#