Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 522)

466 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
23
IGMP Filtering and Throttling
• When the access mode is set to permit, IGMP join reports are processed when a multicast
group falls within the controlled range. When the access mode is set to deny, IGMP join reports
are only processed when a multicast group is not in the controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#
range
This command specifies multicast group addresses for a profile. Use the no form to delete
addresses from a profile.
Syntax
[no] range low-ip-address [high-ip-address]
low-ip-address - A valid IP address of a multicast group or start of a group range.
high-ip-address - A valid IP address for the end of a multicast group range.
Default Setting
None
Command Mode
IGMP Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address or address range
for a profile.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config-igmp-profile)#
ip igmp filter (Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use the no form to
remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration