Efm oam mode, Clear efm oam counters – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 629
Brocade 6910 Ethernet Access Switch Configuration Guide
573
53-1002651-02
26
OAM Commands
efm oam mode
This command sets the OAM mode on the specified port. Use the no form to restore the default
setting.
Syntax
efm oam mode {active | passive}
no efm oam mode
active - All OAM functions are enabled.
passive - All OAM functions are enabled, except for OAM discovery, and sending loopback
control OAMPDUs.
Default Setting
Active
Command Mode
Interface Configuration
Command Usage
When set to active mode, the selected interface will initiate the OAM discovery process. When in
passive mode, it can only respond to discovery messages.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam mode active
Console(config-if)#
clear efm oam counters
This command clears statistical counters for various OAMPDU message types.
Syntax
clear efm oam counters [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Privileged Exec
Example
Console#clear efm oam counters
Console#
Related Commands