Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 372)

316 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
16
Automatic Traffic Control Commands
auto-traffic-control auto-control-release
This command automatically releases a control response of rate-limiting after the time specified in
the
auto-traffic-control release-timer command has expired.
Syntax
auto-traffic-control {broadcast | multicast}
auto-control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• This command can be used to automatically stop a control response of rate-limiting after the
specified action has been triggered and the release timer has expired.
• To release a control response which has shut down a port after the specified action has been
triggered and the release timer has expired, use the
auto-traffic-control control-release
command.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
auto-traffic-control control-release
This command manually releases a control response.
Syntax
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
Command Mode
Interface Configuration (Ethernet)
Command Usage
This command can be used to manually stop a control response of rate-limiting or port shutdown
any time after the specified action has been triggered.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release
Console(config-if)#