Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 146)

90 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
SMTP Alerts
logging sendmail
This command enables SMTP event handling. Use the no form to disable this function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use the no form to remove
an SMTP server.
Syntax
[no] logging sendmail host ip-address
ip-address - IPv4 or IPv6 address of an SMTP server that will be sent alert messages for
event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• You can specify up to three SMTP servers for event handing. However, you must enter a
separate command to specify each server.
• To send email alerts, the switch first opens a connection, sends all the email alerts waiting in
the queue one by one, and finally closes the connection.
logging sendmail
destination- email Email recipients of alert messages GC
logging sendmail
source-email Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
TABLE 22 Event Logging Commands (Continued)
Command Function Mode