Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1069)

Brocade 6910 Ethernet Access Switch Configuration Guide 1013
53-1002651-02
43
Connectivity Fault Management
To show delay-measure attribute groups:
1. Click Administration, CFM.
2. Select Configure Periodic Delay Measure from the Step list.
3. Select Show Group from the Action list.
FIGURE 306 Showing Delay-Measure Attribute Groups
To transmit perioic delay-measure messages:
1. Click Administration, CFM.
2. Select Configure Periodic Delay Measure from the Step list.
3. Select Configure from the Action list.
4. Select the index for the MD, MA and MEP, and then click Query.
5. Mark the Status box to enable periodic transmission of delay-measure messages.
6. Set the transmission method to One-Way or Two-Way.
7. Select one of the group indexes.
8. Specify the target MEP by entering its ID or MAC address.
FIGURE 307 Transmitting Delay-Measure Messages