Reload (global configuration), Reload – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 96

40
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
4
General Commands
Command Mode
Global Configuration
Example
Console(config)#prompt RD2
RD2(config)#
reload (Global Configuration)
This command restarts the system at a specified time, after a specified delay, or at a periodic
interval. You can reboot the system immediately, or you can configure the switch to reset after a
specified amount of time. Use the cancel option to remove a configured setting.
Syntax
reload {at hour minute [{month day | day month} [year]] |
in {hour hours | minute minutes | hour hours minute minutes} |
regularity hour minute [period {daily | weekly day-of-week | monthly day}] |
cancel [at | in | regularity]}
reload at - A specified time at which to reload the switch.
hour - The hour at which to reload. (Range: 0-23)
minute - The minute at which to reload. (Range: 0-59)
month - The month at which to reload. (january ... december)
day - The day of the month at which to reload. (Range: 1-31)
year - The year at which to reload. (Range: 2001-2050)
reload in - An interval after which to reload the switch.
hours - The number of hours, combined with the minutes, before the switch resets.
(Range: 0-576)
minutes - The number of minutes, combined with the hours, before the switch resets.
(Range: 0-59)
reload regularity - A periodic interval at which to reload the switch.
hour - The hour at which to reload. (Range: 0-23)
minute - The minute at which to reload. (Range: 0-59)
day-of-week - Day of the week at which to reload.
(Range: monday ... saturday)
day - Day of the month at which to reload. (Range: 1-31)
reload cancel - Cancels the specified reload option.
Default Setting
None
Command Mode
Global Configuration