Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 717

Brocade 6910 Ethernet Access Switch Configuration Guide
661
53-1002651-02
32
Navigating the Web Browser Interface
Modify
Configures group name and administrative status
Edit Member by VLAN
Specifies VLAN attributes per VLAN
Edit Member by Interface
Specifies VLAN attributes per interface
Edit Member by Interface Range
Specifies VLAN attributes per interface range
Dynamic
Configure General
Enables GVRP VLAN registration protocol globally
Configure Interface
Configures GVRP status and timers per interface
Show Dynamic VLAN
Show VLAN
Shows the VLANs this switch has joined through GVRP
Show VLAN Member
Shows the interfaces assigned to a VLAN through GVRP
Tunnel
IEEE 802.1Q (QinQ) Tunneling
Configure Global
Sets tunnel mode for the switch
Configure Service
Sets a CVLAN to SPVLAN mapping entry
Configure Interface
Sets the tunnel mode for any participating interface
Protocol
Configure Protocol
Add
Creates a protocol group, specifying supported protocols
Show
Shows configured protocol groups
Configure Interface
Add
Maps a protocol group to a VLAN
Show
Shows the protocol groups mapped to each VLAN
IP Subnet
Configure Subnet VLAN
Add
Maps IP subnet traffic to a VLAN
Show
Shows IP subnet to VLAN mapping
Configure Interface
Add
Maps IP subnet traffic to a port/trunk
Show
Shows IP subnet to port/trunk mapping
MAC-Based
Add
Maps traffic with specified source MAC address to a VLAN
Show
Shows source MAC address to VLAN mapping
Mirror
Add
Mirrors traffic from one or more source VLANs to a target port
Show
Shows mirror list
Translation
Add
Maps VLAN IDs between the customer and service provider
TABLE 153
Switch Main Menu (Continued)
Menu
Description
Page