Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 95)

Brocade 6910 Ethernet Access Switch Configuration Guide 39
53-1002651-02
Chapter
4
General Commands
In this chapter
General commands are used to control the command access mode, configuration mode, and other
basic functions.
prompt
This command customizes the CLI prompt. Use the no form to restore the default prompt.
Syntax
prompt string
no prompt
string - Any alphanumeric string to use for the CLI prompt. (Maximum length: 255
characters)
Default Setting
Console
TABLE 9 General Commands
Command Function Mode
prompt Customizes the CLI prompt GC
reload Restarts the system at a specified time, after a specified delay, or at a periodic
interval GC
enable Activates privileged mode NE
quit Exits a CLI session NE, PE
show history Shows the command history buffer NE, PE
configure Activates global configuration mode PE
disable Returns to normal mode from privileged mode PE
reload Restarts the system immediately PE
show reload Displays the current reload settings, and the time at which next scheduled reload
will take place PE
end Returns to Privileged Exec mode any config.
mode
exit Returns to the previous configuration mode, or exits the CLI any mode
help Shows how to use help any mode
? Shows options for command completion (context sensitive) any mode