Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1024)

968 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
Simple Network Management Protocol
Interface
To configure trap managers:
1. Click Administration, SNMP.
2. Select Configure Trap from the Step list.
3. Select Add from the Action list.
4. Fill in the required parameters based on the selected SNMP version.
5. Click Apply
FIGURE 268 Configuring Trap Managers (SNMPv1)
FIGURE 269 Configuring Trap Managers (SNMPv2c)