Mac acls, Access-list mac, Table 60 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 301

Brocade 6910 Ethernet Access Switch Configuration Guide
245
53-1002651-02
11
MAC ACLs
Console#
Related Commands
MAC ACLs
The commands in this section configure ACLs based on hardware addresses, packet format, and
Ethernet type. To configure MAC ACLs, first create an access list containing the required permit or
deny rules, and then bind the access list to one or more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode. Use the no form to
remove the specified ACL.
Syntax
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no spaces or other special
characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
•
When you create a new ACL or enter configuration mode for an existing ACL, use the permit or
deny command to add new rules to the bottom of the list.
•
To remove a rule, use the no permit or no deny command followed by the exact text of a
previously configured rule.
•
An ACL can contain up to 128 rules.
Example
Console(config)#access-list mac jerry
Console(config-mac-acl)#
TABLE 60
MAC ACL Commands
Command
Function
Mode
Creates a MAC ACL and enters configuration mode
GC
Filters packets matching a specified source and destination address,
packet format, and Ethernet type
MAC-ACL
Binds a MAC ACL to a port
IC
Shows port assignments for MAC ACLs
PE
Displays the rules for configured MAC ACLs
PE