Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 745)

Brocade 6910 Ethernet Access Switch Configuration Guide 689
53-1002651-02
33
Setting the System Clock
FIGURE 20 Setting the Polling Interval for SNTP
Specifying SNTP Time Servers
Use the System > Time (Configure Time Server) page to specify the IP address for up to three SNTP
time servers.
CLI References
• “sntp server” on page 95
Parameters
The following parameters are displayed:
• SNTP Server IP Address – Sets the IPv4 or IPv6 address for up to three time servers. The
switch attempts to update the time from the first server, if this fails it attempts an update from
the next server in the sequence.
Interface
To set the SNTP time servers:
1. Click System, then Time.
2. Select Configure Time Server from the Step list.
3. Enter the IP address of up to three time servers.
4. Click Apply.
FIGURE 21 Specifying SNTP Time Servers