Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 633)

Brocade 6910 Ethernet Access Switch Configuration Guide 577
53-1002651-02
26
OAM Commands
Console#
show efm oam remote-loopback interface
This command displays the results of an OAM remote loopback test.
Syntax
show efm oam remote-loopback interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1 10000 9999 0.01 %
Console#
show efm oam status interface
This command displays OAM configuration settings and event counters.
Syntax
show efm oam status interface [interface-list] [brief]
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
brief - Displays a brief list of OAM configuration states.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam status interface 1/1
OAM information of Eth 1/1:
Basic Information:
Admin State : Enabled
Operation State : Operational
Mode : Active
Remote Loopback : Disabled
Remote Loopback Status : No loopback