Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 561)

Brocade 6910 Ethernet Access Switch Configuration Guide 505
53-1002651-02
24
LLDP Commands
Command Usage
The port description is taken from the ifDescr object in RFC 2863, which includes information
about the manufacturer, the product name, and the version of the interface hardware/software.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv port-description
Console(config-if)#
lldp basic-tlv system-capabilities
This command configures an LLDP-enabled port to advertise its system capabilities. Use the no
form to disable this feature.
Syntax
[no] lldp basic-tlv system-capabilities
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The system capabilities identifies the primary function(s) of the system and whether or not these
primary functions are enabled. The information advertised by this TLV is described in IEEE
802.1AB.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv system-capabilities
Console(config-if)#
lldp basic-tlv system-description
This command configures an LLDP-enabled port to advertise the system description. Use the no
form to disable this feature.
Syntax
[no] lldp basic-tlv system-description
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The system description is taken from the sysDescr object in RFC 3418, which includes the full
name and version identification of the system's hardware type, software operating system, and
networking software.