Show vlan-translation, Configuring port-based traffic segmentation, Table 90 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 452

396
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
20
Configuring Port-based Traffic Segmentation
show vlan-translation
This command displays the configuration settings for VLAN translation.
Syntax
show vlan-translation [interface interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show vlan-translation
Interface Old VID New VID
--------- ------- -------
Eth 1/ 1 10 100
Console#
Configuring Port-based Traffic Segmentation
If tighter security is required for passing traffic from different clients through downlink ports on the
local network and over uplink ports to the service provider, port-based traffic segmentation can be
used to isolate traffic for individual clients.
Traffic belonging to each client is isolated to the allocated downlink ports. But the switch can be
configured to either isolate traffic passing across a client’s allocated uplink ports from the uplink
ports assigned to other clients, or to forward traffic through the uplink ports used by other clients,
allowing different clients to share access to their uplink ports where security is less likely to be
compromised.
TABLE 90
Commands for Configuring Traffic Segmentation
Command
Function
Mode
Enables traffic segmentation
GC
Creates a client session
GC
traffic-segmentation
uplink/downlink
Configures uplink/downlink ports for client sessions
GC
traffic-segmentation
uplink-to-uplink
Specifies whether or not traffic can be forwarded between
uplink ports assigned to different client sessions
GC
Displays the configured traffic segments
PE