Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 780)

724 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
34
Port Configuration
Interface
To configure loopback testing on a port:
1. Click Interface, Port, Ethernet Loopback.
2. Select Configure from the Action list.
3. Select a port from the drop-down list, set the Status to Enabled, and enter one or more VLANs
associated with the port.
4. Click Apply.
FIGURE 52 Performing Loopback Testing
To show the adminstative status of loopback testing for each port, and the associated VLANs:
1. Click Interface, Port, Ethernet Loopback.
2. Select Show Information from the Action list.
3. Select a port from the drop-down list.
4. Click Apply.
FIGURE 53 Showing Configured Settings for Loopback Testing
To show the adminstative status of loopback testing for each port, and the associated VLANs:
1. Click Interface, Port, Ethernet Loopback.
2. Select Show Information from the Action list.
3. Select a port from the drop-down list.
4. Click Apply.