beautypg.com

Debug hardware dev-swdrv – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 694

background image

638

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

31

Debug Commands

[512]pcl_id=512, hw_idx=118, upper_rule_id=56, policer_idx=-1, pce_type=4(EXT), valid=1

pattern:00000000 00000000 00000000 00000800 00000000 00000000 00000000 00000000

00000000 00000000 7003C000 00748EF8

mask:000001FF 00000000 00000000 00000800 00000000 00000000 00000000 00000000

00000000 00000000 FFFFFF00 00FFFFFF

action:00000000 00000000 00000000 00000000 Forward

Console#

debug hardware dev-swdrv

This command shows the switch driver’s buffer allocation for packets, including the status of
packet buffers, counter for dropped packets over a period of time, counter for registers of all PHY
ports, mapping between physical ports and MAC ports, and configuration of all Spanning Trees.

Syntax

debug hardware dev-swdrv {buff-cnt | drop-cnt | phy-cnt | port-map | stg}

buff-cnt – Shows allocation status of packet buffers.

drop-cnt – Shows the counter for dropped packets over a period of time.

phy-cnt – Shows the counter for the registers of all PHY ports.

port-map – Shows the mapping between physical ports and MAC ports

stg – Shows the configuration of all Spanning Trees.

Command Mode
Privileged Exec

Example

Console#debug hardware dev-swdrv buff-cnt

================= Buffers Allocation Counters ================

Data = 0x0 , AgedPacketCnt[0-12][ROC] = 0x0

Data = 0x57 , TotalBuffAllocCnt[0-12][RW] = 0x57

Data = 0x0 , PacketCounter[0-12][RW] = 0x0

Buffers Allocation Counter Register (n=0~27)>

Offset Formula: 0x03000100+n * 0x4: where n present port

Data = 0x3 , Port< 0>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 1>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 2>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 3>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 4>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 5>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 6>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 7>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 8>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port< 9>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port<10>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port<11>BuffAllocCnt[0-12][RW] = 0x3

Data = 0x3 , Port<12>BuffAllocCnt[0-12][RW] = 0x3

Console#