Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 136)

80 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
Line
Default Setting
The default value is three attempts.
Command Mode
Line Configuration
Command Usage
When the logon attempt threshold is reached, the system interface becomes silent for a specified
amount of time before allowing the next logon attempt. (Use the
silent-time command to set this
interval.) When this threshold is reached for Telnet, the Telnet logon interface shuts down.
Example
To set the password threshold to five attempts, enter this command:
Console(config-line)#password-thresh 5
Console(config-line)#
Related Commands
“silent-time” on page 80
silent-time
This command sets the amount of time the management console is inaccessible after the number
of unsuccessful logon attempts exceeds the threshold set by the
password-thresh command. Use
the no form to remove the silent time value.
Syntax
silent-time [seconds]
no silent-time
seconds - The number of seconds to disable console response. (Range: 0-65535, where 0
means disabled)
Default Setting
The default value is no silent-time.
Command Mode
Line Configuration
Example
To set the silent time to 60 seconds, enter this command:
Console(config-line)#silent-time 60
Console(config-line)#
Related Commands
“password-thresh” on page 79