Show ip igmp snooping group – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 515

Brocade 6910 Ethernet Access Switch Configuration Guide
459
53-1002651-02
23
IGMP Snooping
Version Exclusive : Disabled
Version : 2
Proxy Reporting : Disabled
Querier : Disabled
VLAN 1:
--------
IGMP Snooping : Enabled
IGMP Snooping Running Status : Inactive
Version : Using global Version (2)
Version Exclusive : Using global status (Disabled)
Immediate Leave : Disabled
Last Member Query Interval : 10 (unit: 1/10s)
Last Member Query Count : 2
General Query Suppression : Disabled
Query Interval : 125
Query Response Interval : 100 (unit: 1/10s)
Proxy Query Address : 0.0.0.0
Proxy Reporting : Using global status (Disabled)
Multicast Router Discovery : Disabled
VLAN Static Group Port
---- --------------- --------
1 224.1.1.1 Eth 1/ 1
.
.
.
show ip igmp snooping group
This command shows known multicast group, source, and host port mappings for the specified
VLAN interface, or for all interfaces if none is specified.
Syntax
show ip igmp snooping group [host-ip-addr ip-address interface | igmpsnp | sort-by-port |
user | vlan vlan-id [user | igmpsnp]]
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
igmpsnp - Display only entries learned through IGMP snooping.
sort-by-port - Display entries sorted by port.
user - Display only the user-configured multicast entries.
vlan-id - VLAN ID (1-4093)
Default Setting
None