beautypg.com

Show mvr6, Table 118 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 549

background image

Brocade 6910 Ethernet Access Switch Configuration Guide

493

53-1002651-02

23

MVR for IPv6

Example
The following statically assigns a multicast group to a receiver port:

Console(config)#interface ethernet 1/2

Console(config-if)#mvr6 domain 1 type receiver

Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1

Console(config-if)#

show mvr6

This command shows information about MVR domain settings, including MVR operational status,
the multicast VLAN, the current number of group addresses, and the upstream source IP address.

Syntax

show mvr6 [domain domain-id]

domain-id - An independent multicast domain. (Range: 1-5)

Default Setting
Displays configuration settings for all MVR domains.

Command Mode
Privileged Exec

Example
The following shows the MVR settings:

Console#show mvr6

MVR6 Proxy Switching : Enabled

MVR6 Robustness Value : 1

MVR6 Domain : 1

MVR6 Config Status : Enabled

MVR6 Running Status : Active

MVR6 Multicast VLAN : 1

MVR6 Upstream Source IP : FF05::25

Console#

TABLE 118

show mvr6 - display description

Field

Description

MVR Proxy Switching

Shows if MVR proxy switching is enabled

MVR Robustness Value

Shows the number of reports or query messages sent when proxy switching is
enabled

MVR6 Domain

An independent multicast domain.

MVR6 Config Status

Shows if MVR is globally enabled on the switch.

MVR6 Running Status

Indicates whether or not all necessary conditions in the MVR environment are
satisfied. (Running status is true as long as MVR Status is enabled, and the
specified MVR VLAN exists, and a source port with a valid link has been configured
(using the

mvr6 type

command.)

MVR6 Multicast VLAN

Shows the VLAN used to transport all MVR multicast traffic.

MVR6 Upstream Source IP

The source IP address assigned to all upstream control packets.