Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 635)

Brocade 6910 Ethernet Access Switch Configuration Guide 579
53-1002651-02
Chapter
27
Domain Name Service Commands
In this chapter
These commands are used to configure Domain Naming System (DNS) services. Entries can be
manually configured in the DNS domain name to IP address mapping table, default domain names
configured, or one or more name servers specified to use for domain name to address translation.
Note that domain name services will not be enabled until at least one name server is specified with
the
ip name-server command and domain lookup is enabled with the ip domain-lookup command.
ip domain-list
This command defines a list of domain names that can be appended to incomplete host names
(i.e., host names passed from a client that are not formatted with dotted notation). Use the no form
to remove a name from this list.
Syntax
[no] ip domain-list name
name - Name of the host. Do not include the initial dot that separates the host name from
the domain name. (Range: 1-127 characters)
Default Setting
None
Command Mode
Global Configuration
TABLE 135 Address Table Commands
Command Function Mode
ip domain-list Defines a list of default domain names for incomplete host names GC
ip domain-lookup Enables DNS-based host name-to-address translation GC
ip domain-name Defines a default domain name for incomplete host names GC
ip host Creates a static IPv4 host name-to-address mapping GC
ip name-server Specifies the address of one or more name servers to use for host
name-to-address translation GC
ipv6 host Creates a static IPv6 host name-to-address mapping GC
clear dns cache Clears all entries from the DNS cache PE
clear host Deletes entries from the host name-to-address table PE
show dns Displays the configuration for DNS services PE
show dns cache Displays entries in the DNS cache PE
show hosts Displays the static host name-to-address mapping table PE