Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 332)

276 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
12
Interface Commands
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q-tunnel Status : Disable
802.1Q-tunnel Mode : NORMAL
802.1Q-tunnel TPID : 8100(Hex)
Console#
TABLE 64 show interfaces switchport - display description
Field Description
Broadcast
Threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also shows the
threshold level (see
“switchport packet-rate” on page 263).
Multicast Threshold Shows if multicast storm suppression is enabled or disabled; if enabled it also shows the
threshold level (see
“switchport packet-rate” on page 263).
Unknown-unicast
Threshold Shows if unknown unicast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (see
“switchport packet-rate” on page 263).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled (see “lacp” on
page 288).
Ingress/Egress Rate
Limit Shows if rate limiting is enabled, and the current rate limit (see “rate-limit” on page 307).
VLAN Membership
Mode Indicates membership mode as Trunk or Hybrid (see “switchport mode” on page 381).
Ingress Rule Shows if ingress filtering is enabled or disabled (see “switchport ingress-filtering” on
page 380).
Acceptable Frame
Type Shows if acceptable VLAN frames include all types or tagged frames only (see “switchport
acceptable-frame-types” on page 378).
Native VLAN Indicates the default Port VLAN ID (see “switchport native vlan” on page 381).
Priority for Untagged
Traffic Indicates the default priority for untagged frames (see “switchport priority default” on
page 418).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled (see “switchport gvrp” on
page 372).