Radius client, Radius-server acct-port, Radius-server auth-port – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 200: Radius-server acct-port radius-server auth-port, Table 37

144
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
RADIUS Client
RADIUS Client
Remote Authentication Dial-in User Service (RADIUS) is a logon authentication protocol that uses
software running on a central server to control access to RADIUS-aware devices on the network. An
authentication server contains a database of multiple user name/password pairs with associated
privilege levels for each user or group that require management access to a switch.
radius-server acct-port
This command sets the RADIUS server network port for accounting messages. Use the no form to
restore the default.
Syntax
radius-server acct-port port-number
no radius-server acct-port
port-number - RADIUS server UDP port used for accounting messages. (Range: 1-65535)
Default Setting
1813
Command Mode
Global Configuration
Example
Console(config)#radius-server acct-port 181
Console(config)#
radius-server auth-port
This command sets the RADIUS server network port. Use the no form to restore the default.
Syntax
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
TABLE 37
RADIUS Client Commands
Command
Function
Mode
Sets the RADIUS server network port
GC
Sets the RADIUS server network port
GC
Specifies the RADIUS server
GC
Sets the RADIUS encryption key
GC
Sets the number of retries
GC
Sets the interval between sending authentication requests
GC
Shows the current RADIUS settings
PE