Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 790)

734 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
34
Trunk Configuration
Interface
To display LACP port counters:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Show Information from the Action list.
4. Click Counters.
5. Select a group member from the Port list.
FIGURE 67 Displaying LACP Port Counters
Displaying LACP Settings and Status for the Local Side
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show Information - Internal)
page to display the configuration settings and operational state for the local side of a link
aggregation.
CLI References
• “show lacp” on page 293
Parameters
These parameters are displayed:
TABLE 157 LACP Internal Configuration Information
Parameter Description
LACP System Priority LACP system priority assigned to this port channel.
LACP Port Priority LACP port priority assigned to this interface within the channel group.
Admin Key Current administrative value of the key for the aggregation port.
Oper Key Current operational value of the key for the aggregation port.
LACPDUs Interval Number of seconds before invalidating received LACPDU information.