Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 482)

426 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
21
Priority Commands (Layer 3 and 4)
show qos map phb-queue
This command shows internal per-hop behavior to hardware queue map.
Syntax
show qos map phb-queue interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show qos map phb-queue interface ethernet 1/5
Information of Eth 1/5
PHB-queue map:
PHB: 0 1 2 3 4 5 6 7
-------------------------------------------------------
queue: 2 0 1 3 4 5 6 7
Console#
show qos map trust-mode
This command shows the QoS mapping mode.
Syntax
show qos map trust-mode interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
The following shows that the trust mode is set to CoS:
Console#show qos map trust-mode interface ethernet 1/5
Information of Eth 1/5
CoS Map Mode: CoS mode
Console#