Configuring snmpv3 groups – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 1015
Brocade 6910 Ethernet Access Switch Configuration Guide
959
53-1002651-02
43
Simple Network Management Protocol
Configuring SNMPv3 Groups
Use the Administration > SNMP (Configure Group) page to add an SNMPv3 group which can be
used to set the access policy for its assigned users, restricting them to specific read, write, and
notify views. You can use the pre-defined default groups or create new groups to map a set of
SNMP users to SNMP views.
CLI References
•
Parameters
These parameters are displayed:
•
Group Name – The name of the SNMP group to which the user is assigned. (Range: 1-32
characters)
•
Security Model – The user security model; SNMP v1, v2c or v3.
•
Security Level – The following security levels are only used for the groups assigned to the
SNMP security model:
•
noAuthNoPriv – There is no authentication or encryption used in SNMP communications.
(This is the default security level.)
•
AuthNoPriv – SNMP communications use authentication, but the data is not encrypted.
•
AuthPriv – SNMP communications use both authentication and encryption.
•
Read View – The configured view for read access. (Range: 1-32 characters)
•
Write View – The configured view for write access. (Range: 1-32 characters)
•
Notify View – The configured view for notifications. (Range: 1-32 characters)
For a list of supported notification messages, see the Brocade 6910 Ethernet Access Switch
MIB Reference.
Interface
To configure an SNMP group:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Add from the Action list.
4. Enter a group name, assign a security model and level, and then select read, write, and notify
views.
5. Click Apply