Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 545)

Brocade 6910 Ethernet Access Switch Configuration Guide 489
53-1002651-02
23
MVR for IPv6
mvr6 robustness-value
This command configures the expected packet loss, and thereby the number of times to generate
report and group-specific queries. Use the no form to restore the default setting.
Syntax
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
Default Setting
1
Command Mode
Global Configuration
Command Usage
• This command is used to set the number of times report messages are sent upstream when
changes are learned about downstream groups, and the number of times group-specific
queries are sent to downstream receiver ports.
• This command only takes effect when MVR6 proxy switching is enabled.
Example
Console(config)#mvr6 robustness-value 5
Console(config)#
Related Commands
“mvr6 proxy-switching” on page 488
mvr6 upstream-source-ip
This command configures the source IPv6 address assigned to all MVR control packets sent
upstream on the specified domain. Use the no form to restore the default setting.
Syntax
mvr6 domain domain-id upstream-source-ip source-ip-address
no mvr6 domain domain-id upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv6 address assigned to all MVR control packets sent
upstream. This parameter must be a full IPv6 address including the network prefix and
host address bits.
Default Setting
All MVR reports sent upstream use a null source IP address
Command Mode
Global Configuration