Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 621)

Brocade 6910 Ethernet Access Switch Configuration Guide 565
53-1002651-02
25
CFM Commands
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• If the specified attribute group has not been configured by the ethernet cfm loss-measure
single-ended group command, the binding will fail.
• If an attribute group is bound to any MEP, the attributes of that group cannot be modified.
• To change the binding for a MEP, loss-measure messages must be disabled.
Example
This example shows an attribute group bound to a MEP.
Console(config)#ethernet cfm loss-measure single-ended binding group 1 md voip
ma rd mpid 1
Console(config)#
ethernet cfm loss-measure single-ended destination
This command sets the destination MEP for periodically transmitted loss-measure messages.. Use
the no form to clear a destination.
Syntax
ethernet cfm loss-measure single-ended destination dest-mep destination-mpid
md domain-name ma ma-name mpid source-mpid
no ethernet cfm delay-measure destination md domain-name ma ma-name mpid mpid
destination-mpid – The identifier of a remote MEP that is the target of loss-measure
messages. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
source-mpid – Maintenance end point identifier of a local MEP that is the source of
loss-measure messages. (Range: 1-8191)
Default Setting
None
Command Mode
Global Configuration