Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 139)

Brocade 6910 Ethernet Access Switch Configuration Guide 83
53-1002651-02
5
Event Logging
Related Commands
“show ssh” on page 172
“show users” on page 63
show line
This command displays the terminal line’s parameters.
Syntax
show line [console | vty]
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
Shows all lines
Command Mode
Normal Exec, Privileged Exec
Example
To show all lines, enter this command:
Console#show line
Console Configuration:
Password Threshold : 3 times
Inactive Timeout : Disabled
Login Timeout : Disabled
Silent Time : Disabled
Baud Rate : Auto
Data Bits : 8
Parity : None
Stop Bits : 1
VTY Configuration:
Password Threshold : 3 times
Inactive Timeout : 600 seconds
Login Timeout : 300 sec.
Silent Time : Disabled
Console#
Event Logging
This section describes commands used to configure event logging on the switch.
TABLE 18 Event Logging Commands
Command Function Mode
logging facility Sets the facility type for remote logging of syslog messages GC
logging history Limits syslog messages saved to switch memory based on severity GC
logging host Adds a syslog server host IP address that will receive logging
messages GC