Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 634)

578 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
26
OAM Commands
Dying Gasp : Enabled
Critical Event : Enabled
Link Monitor (Errored Frame) : Enabled
Link Monitor:
Errored Frame Window (100msec) : 10
Errored Frame Threshold : 1
Console#show efm oam status interface 1/1 brief
$ = local OAM in loopback
* = remote OAM in loopback
Port Admin Mode Remote Dying Critical Errored
State Loopback Gasp Event Frame
---- ------- ------- -------- ------- -------- -------
1/1 Enabled Active Disabled Enabled Enabled Enabled
Console#
show efm oam status remote interface
This command displays information about attached OAM-enabled devices.
Syntax
show efm oam status remote interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam status remote interface 1/1
Port MAC Address OUI Remote Unidirectional Link MIB Variable
Loopback Monitor Retrieval
---- ----------------- ------ -------- -------------- ------- ------------
1/1 00-12-CF-6A-07-F6 000084 Enabled Disabled Enabled Disabled
Console#