Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 618)

562 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
25
CFM Commands
Jun 18 05:04:39 2012 10 10
Jun 18 05:04:40 2012 10 0
Jun 18 05:04:41 2012 < 10 10
Delay time min/avg/max=0/12/20 ms.
Console#
Loss Measure Operations
ethernet cfm loss-measure dual-ended destination
This command sets the destination MEP for periodically transmitted continuity check messages
(CCM), including request for dual-ended frame loss measurements. Use the no form to clear a
destination.
Syntax
ethernet cfm loss-measure dual-ended destination dest-mep destination-mpid
md domain-name ma ma-name mpid source-mpid
no ethernet cfm delay-measure destination md domain-name ma ma-name mpid mpid
destination-mpid – The identifier of a remote MEP that is the target of loss-measure
messages. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
source-mpid – Maintenance end point identifier of a local MEP that is the source of
loss-measure messages. (Range: 1-8191)
Default Setting
None
Command Mode
Global Configuration
Command Usage
To modify settings for a destination, first disable the transmission of loss-measure messages with
the
no ethernet cfm loss-measure enable command.
Example
This example sets the periodic loss-measure message destination for a MEP.
Console(config)#ethernet cfm loss-measure dual-ended destination dest-mep 2
md voip ma rd mpid 1
Console(config)#