Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 566)

510 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
24
LLDP Commands
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP changes. Use the
no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at the interval
specified by the
lldp notification-interval command. Trap notifications include information
about state changes in the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command.
• Information about additional changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a trap notification
are included in the transmission. An SNMP agent should therefore periodically check the value
of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange notification-events
missed due to throttling or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#
show lldp config
This command shows LLDP configuration settings for all ports.
Syntax
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec