Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 52)

l Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
Summary of enhancements for Brocade R2.2.0.2
The following table describes the changes included in R2.2.0.2.
Summary of enhancements for Brocade R2.2.0.0
The following table describes the features introduced in R2.2.0.0
Enhancement Description
Configuring the destination
MAC address for CFM two-way
delay-measure as a multicast
MAC address is no longer
supported The target address of the MPID for CFM two-way delay-measure can no longer be
configured as a multicast MAC address. See
“ethernet cfm delay-measure
two-way” on page 560, and “Transmitting Periodic Delay-Measure Messages” on
page 1010.
Updated description for “show
ip dhcp relay” command Information for the command syntax and display output of the “show ip dhcp
relay” command was corrected. See
“show ip dhcp relay” on page 594.
Enhancement Description
Added exception log option to
copy command Added exception log option which allows the crash dump file exception_log.tgz to
be copied to a file server. See
“copy” on page 67.
Added 3DS encryption to
“snmp-server user” command Added 3DS encryption option to “snmp-server user” command. See “snmp-server
user” on page 115, “Configuring Local SNMPv3 Users” on page 962, and
“Configuring Remote SNMPv3 Users” on page 963.
Added “sflow forwarding”
command Added “sflow forwarding” command to enable forwarding of samples to the sFlow
Collector on the specified interface. See
“sflow forwarding” on page 134 and the
Parameters section under “Configuring sFlow Interface Settings” on page 741.
Removed symmetric option
from “capabilities” command Removed symmetric option from “capabilities” command due to chip limitation.
See
“capabilities” on page 258, and “Configuring by Port List” on page 701.
Added “ethernet loopback”
test command Added “ethernet loopback” command which loops traffic back from destination
port to source port. See
“ethernet loopback” on page 280 and “Performing
Loopback Testing” on page 722.
Added “vlan mac-learning”
command Added “vlan mac-learning” command which floods ingress traffic to all ports in
the specified VLAN when using the no form of this command. See
“vlan
mac-learning” on page 376, and “Configuring VLAN Groups” on page 752.
Added periodic two-way delay
measure CFM commands Added periodic two-way delay measure CFM commands. See “Delay Measure
Operations” on page 554, “Transmitting Periodic Delay-Measure Messages” on
page 1010, “Transmitting On-Demand Delay-Measure Requests” on page 1021.
Added one-way delay measure
CFM commands Added periodic and on-demand one-way delay measure CFM commands. See
“Delay Measure Operations” on page 554, “Transmitting Periodic Delay-Measure
Messages” on page 1010, and “Transmitting On-Demand Delay-Measure
Requests” on page 1021.
Added loss-measure CFM
commands Added loss-measure dual-ended and single-ended CFM commands. See “Loss
Measure Operations” on page 562, “Transmitting Periodic Loss-Measure
Messages” on page 1014, and “Transmitting On-Demand Loss-Measure
Requests” on page 1024.