Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 521)

Brocade 6910 Ethernet Access Switch Configuration Guide 465
53-1002651-02
23
IGMP Filtering and Throttling
• IGMP filtering and throttling only applies to dynamically learned multicast groups, it does not
apply to statically configured groups.
• The IGMP filtering feature operates in the same manner when MVR is used to forward
multicast traffic.
Example
Console(config)#ip igmp filter
Console(config)#
ip igmp profile
This command creates an IGMP filter profile number and enters IGMP profile configuration mode.
Use the no form to delete a profile number.
Syntax
[no] ip igmp profile profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
A profile defines the multicast groups that a subscriber is permitted or denied to join. The same
profile can be applied to many interfaces, but only one profile can be assigned to one interface.
Each profile has only one access mode; either permit or deny.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
permit, deny
This command sets the access mode for an IGMP filter profile. Use the no form to delete a profile
number.
Syntax
{permit | deny}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
• Each profile has only one access mode; either permit or deny.