Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 218)

162 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
Telnet Server
Telnet Server
This section describes commands used to configure Telnet management access to the switch.
NOTE
This switch also supports a Telnet client function. A Telnet connection can be made from this switch
to another device by entering the telnet command at the Privileged Exec configuration level.
ip telnet max-sessions
This command specifies the maximum number of Telnet sessions that can simultaneously connect
to this system. Use the no from to restore the default setting.
Syntax
ip telnet max-sessions session-count
no ip telnet max-sessions
session-count - The maximum number of allowed Telnet session. (Range: 0-8)
Default Setting
8 sessions
Command Mode
Global Configuration
Command Usage
A maximum of eight sessions can be concurrently opened for Telnet and Secure Shell (i.e., both
Telnet and SSH share a maximum number or eight sessions).
Example
Console(config)#ip telnet max-sessions 1
Console(config)#
TABLE 42 Telnet Server Commands
Command Function Mode
ip telnet max-sessions Specifies the maximum number of Telnet sessions that can
simultaneously connect to this system GC
ip telnet port Specifies the port to be used by the Telnet interface GC
ip telnet server Allows the switch to be monitored or configured from Telnet GC
show ip telnet Displays configuration settings for the Telnet server PE