Enable password – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 196
140
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
User Accounts
enable password
After initially logging onto the system, you should set the Privileged Exec password. Remember to
record it in a safe place. This command controls access to the Privileged Exec level from the Normal
Exec level. Use the no form to reset the default password.
Syntax
enable password [level level] {0 | 7} password
no enable password [level level]
level level - Level 15 for Privileged Exec. (Levels 0-14 are not used.)
{0 | 7} - 0 means plain password, 7 means encrypted password.
password - Password for this privilege level. (Maximum length: 32 characters plain text or
encrypted, case sensitive)
Default Setting
The default is level 15.
The default password is “super”
Command Mode
Global Configuration
Command Usage
•
You cannot set a null password. You will have to enter a password to change the command
mode from Normal Exec to Privileged Exec with the
command.
•
The encrypted password is required for compatibility with legacy password settings (i.e., plain
text or encrypted) when reading the configuration file during system bootup or when
downloading the configuration file from a TFTP server. There is no need for you to manually
configure encrypted passwords.
Example
Console(config)#enable password level 15 0 admin
Console(config)#
Related Commands