beautypg.com

Ethernet cfm delay-measure threshold, Threshold – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 614

background image

558

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

25

CFM Commands

ethernet cfm delay-measure threshold

This command sets the threshold for frame delay measurements at which an SNMP trap is sent
and an entry is recorded in the system log. Use the no form to restore the default setting.

Syntax

ethernet cfm delay-measure threshold threshold

no ethernet cfm delay-measure threshold

threshold - The delay in transmission time at or above which a trap is sent and an entry
recorded in the system log. (Range: 10-500 in units of 10 milliseconds)

Default Setting
100 (1000ms)

Command Mode
Global Configuration

Command Usage

The threshold setting applies to all MEPs.

Use the

snmp-server enable traps ethernet cfm delay-measure threshold

to enable SNMP trap

messages for delay-message transmissions exceeding the specified threshold.

Example
This example sets the threshold for delay-measure message transmissions to 10 (100ms).

Console(config)#ethernet cfm delay-measure threshold 10

Console(config)#

snmp-server enable traps ethernet cfm delay-measure threshold

This command enables SNMP trap generation for delay-measure transmissions at or above a
configured threshold. Use the no form to disable this trap.

Syntax

[no] snmp-server enable traps ethernet cfm delay-measure threshold

Default Setting
Disabled

Command Mode
Global Configuration

Example

Console(config)#snmp-server enable traps ethernet cfm delay-measure threshold

Console(config)#