Configuring interface settings for arp inspection, Figure 219 confi – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 960
904
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
42
ARP Inspection
Parameters
These parameters are displayed:
•
ARP Inspection VLAN ID – Selects any configured VLAN. (Default: 1)
•
ARP Inspection VLAN Status – Enables ARP Inspection for the selected VLAN. (Default:
Disabled)
•
ARP Inspection ACL Name
•
ARP ACL – Allows selection of any configured ARP ACLs. (Default: None)
•
Static – When an ARP ACL is selected, and static mode also selected, the switch only
performs ARP Inspection and bypasses validation against the DHCP Snooping Bindings
database. When an ARP ACL is selected, but static mode is not selected, the switch first
performs ARP Inspection and then validation against the DHCP Snooping Bindings
database. (Default: Disabled)
Interface
To configure VLAN settings for ARP Inspection:
1. Click Security, ARP Inspection.
2. Select Configure VLAN from the Step list.
3. Enable ARP inspection for the required VLANs, select an ARP ACL filter to check for configured
addresses, and select the Static option to bypass checking the DHCP snooping bindings
database if required.
4. Click Apply.
FIGURE 219
Configuring VLAN Settings for ARP Inspection
Configuring Interface Settings for ARP Inspection
Use the Security > ARP Inspection (Configure Interface) page to specify the ports that require ARP
inspection, and to adjust the packet inspection rate.
CLI References
•
Parameters
These parameters are displayed:
•
Interface – Port or trunk identifier.
•
Trust Status – Configures the port as trusted or untrusted. (Default: Untrusted)