Allied Telesis AT-8100 Series - Manual (Page 963)

963
Chapter 63
GARP VLAN Registration Protocol
Commands
The GARP VLAN registration protocol commands are summarized in
Table 101 and described in detail within the chapter.
Table 101. GARP VLAN Registration Protocol Commands
Command Mode Description
“CONVERT DYNAMIC VLAN” on
page 965 VLAN
Configuration Converts dynamic GVRP VLANs and
port assignments to static.
“GVRP APPLICANT STATE ACTIVE”
on page 966 Global
Configuration Enables GIP on the switch.
“GVRP APPLICANT STATE
NORMAL” on page 967 Global
Configuration Disables GIP.
“GVRP ENABLE” on page 968 Global
Configuration Enables GVRP.
“GVRP REGISTRATION” on
page 969 Port Interface Set a port’s GVRP status.
“GVRP TIMER JOIN” on page 970 Global
Configuration Sets the GARP Join Timer.
“GVRP TIMER LEAVE” on page 971 Global
Configuration Sets the GARP Leave Timer.
“GVRP TIMER LEAVEALL” on
page 972 Global
Configuration Sets the GARP Leave All timer.
“NO GVRP ENABLE” on page 973 Global
Configuration Disables GVRP on the switch.
“NO GVRP TIMER JOIN” on page 974 Global
Configuration Disables the GARP Join Timer.
“NO GVRP TIMER LEAVE” on
page 975 Global
Configuration Disables the GARP Leave Timer.
“NO GVRP TIMER LEAVEALL” on
page 976 Global
Configuration Disables the GARP Leave All timer.
“PURGE GVRP” on page 977 Global
Configuration Disables GVRP on the switch and
returns the timers to their default
values.