Allied Telesis AT-8100 Series - Manual (Page 307)

AT-8100 Switch Command Line User’s Guide
307
awplus> enable
awplus# configure terminal
awplus(config)# no ip route 0.0.0.0/0 149.121.43.23
Displaying an
IPv4
Management
Address and
Default Gateway
The easiest way to view the IPv4 management address and default
gateway address of the switch is with the SHOW IP ROUTE command. It
displays both addresses at the same time. The command is found in the
Privileged Exec mode, as shown here:
awplus# show ip route
See Figure 68 for an example of the information. The management IPv4
address of the switch is displayed in the first entry in the table and the
default gateway address, if assigned to the switch, in the second entry.
Figure 68 displays an example of the information.
Figure 68. SHOW IP ROUTE Command
The columns in the display are defined in Table 29 on page 332.
To view only the management IP address, use the SHOW IP INTERFACE
command, also in the Privileged Exec mode:
awplus# show ip interface
Here is an example of the information from the command.
Figure 69. SHOW IP INTERFACE Command
For definitions of the columns: See “SHOW IP INTERFACE” on page 331.
--------------------------------------------------------------------
Destination Mask NextHop Interface Protocol
--------------------------------------------------------------------
192.168.1.0 255.255.255.0 192.168.1.1 vlan1-0 INTERFACE
--------------------------------------------------------------------
Interface IP Address Status Protocol
VLAN14-0 123.94.146.72 admin up down