Ip source binding – Allied Telesis AT-8100 Series User Manual
Page 664
Chapter 44: DHCP Snooping Commands
664
IP SOURCE BINDING
Syntax
ip source binding <
ipaddr
> <
macaddr
>
vlan
<
vid
>
interface
<
port
>
Parameters
ipaddr
Specifies the client’s IP address. If there is already an entry in the
DHCP snooping database for the IP address, then this option
replaces it with the new entry.
macaddr
Specifies a client’s MAC address in the HHHH.HHHH.HHHH
format.
vlan
Specifies a VLAN ID for the entry. The range is from 1 to 4094.
interface
Indicates the port the client is connected to.
Mode
Global Configuration mode
Description
Use this command to add or replace a static entry in the DHCP snooping
database. In addition, you can use this command to delete all of the static
entries in the DHCP snooping database.
Use the no version of the command, NO IP SOURCE BINDING
command, to delete the specified static entry or all static entries from the
database.
To remove dynamic entries from the DHCP snooping database, use the
CLEAR IP DHCP SNOOPING BINDING command (see “IP DHCP
SNOOPING” on page 648) or NO IP DHCP SNOOPING BINDING
command (see “IP DHCP SNOOPING BINDING” on page 651).
Confirmation Commands