Allied Telesis AT-8100 Series - Manual (Page 443)

AT-8100 Switch Command Line User’s Guide
443
RCOMMAND
Syntax
rcommand switch_id
Parameters
switch_id
Specifies the ID number of a member switch you want to manage
in the enhanced stack. This number is displayed with “SHOW
ESTACK REMOTELIST” on page 449. You can enter only one ID
number.
Mode
Global Configuration mode
Description
Use this command to redirect the management session from the
command switch to a member switch in the enhanced stack. The member
switch is identified by its ID number, displayed with “SHOW ESTACK
REMOTELIST” on page 449. You can manage only one member switch at
a time.
Note
You must perform this command from the command switch of the
stack. This command will not work on a member switch.
Note
You should perform the SHOW ESTACK REMOTELIST command
before this command.
When you are finished managing a member switch, use the EXIT
command to return to the command switch.
Example
This example starts a management session on switch number 12:
awplus> enable
awplus# configure terminal
awplus(config)# rcommand 12