Allied Telesis AT-8100 Series - Manual (Page 329)

AT-8100 Switch Command Line User’s Guide
329
NO IPV6 ADDRESS
Syntax
no ipv6 address
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to delete the current IPv6 management address from
the switch. You must perform this command from the VLAN Interface
mode of the VLAN to which the address is attached.
Note
The switch uses the IPv6 management address to perform the
features listed Table 27 on page 300. If you delete it, the switch will
not support the features unless it also has an IPv4 management
address.
Confirmation Command
“SHOW IPV6 INTERFACE” on page 335 and “SHOW IPV6 ROUTE” on
page 336
Example
This example removes the static IPv6 management address from the
VLAN with the VID 3:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# no ipv6 address