Allied Telesis AT-8100 Series - Manual (Page 1724)

Chapter 101: QoS Commands
1724
Confirmation Commands
“SHOW CLASS-MAP” on page 1766
“SHOW RUNNING-CONFIG” on page 170
Examples
The following example assigns an Ethernet format of SNAP tagged
packets and IP to a class map called “cmap1:”
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap1
awplus(config-cmap)# match eth-format snap-tagged protocol
ip
The following example assigns an Ethernet format of 802.2 untagged
packets to a class map called “cmap8:”
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap8
awplus(config-cmap)# match eth-format 802dot2-untagged
proway Indicates protocol number 8E. Enter the
parameter name or its number.
proway-lan Indicates protocol number 0E. Enter the
parameter name or its number.
rarp Indicates protocol number 8035. Enter the
parameter name or its number.
sna-path-control Indicates protocol number 04. Enter the
parameter name or its number.
snmp Indicates protocol number 814C. Enter the
parameter name or its number.
xdot25-level-3 Indicates protocol number 0805. Enter the
parameter name or its number.
xdot75-internet Indicates protocol number 0801. Enter the
parameter name or its number.
xns-compat Indicates protocol number 0807. Enter the
parameter name or its number.
Table 237. Layer Three Protocol (Continued)
Parameter Description