Radius-server host, Radius-server host 0 – Allied Telesis AT-8100 Series User Manual
Page 1510
Chapter 97: RADIUS and TACACS+ Client Commands
1510
RADIUS-SERVER HOST
Syntax
radius-server host
ipaddress
[acct-port
value
] [auth-port
value
] [key
value
]
Parameters
ipaddress
Specifies the IP address of a RADIUS server on the network.
acct-port
Specifies the accounting port. This is the UDP destination port for
RADIUS accounting requests. If 0 is specified, the server is not
used for accounting. The default UDP port for accounting is 1813.
auth-port
Specifies the UDP destination port for RADIUS authentication
requests. If 0 is specified, the server is not used for authentication.
The default UDP port for authentication is 1812.
key
Specifies the encryption key used by the designated RADIUS
server. The maximum length is 40 characters.
Mode
Global Configuration mode
Description
Use this command to add IP addresses of RADIUS servers to the
authentication server list on the switch. Servers defined with this
command are used for remote authentication only.
The switch can have up to three RADIUS authentication servers, but only
one can be added at a time with this command. The order that you add an
IP address determines its order on the switch.
Confirmation Command